Multifors 2 - Parallel Bench-top Bioreactor
Installation and Initial Operation
28 March 2018
Page
105
of
211
master unit and the satellite unit(s) can also be identified by the
numbering on their identification plate:
Serial number and -001 = master unit
Serial number and -002 = 1st satellite unit
Serial number and -003 = 2nd satellite unit
The equipment is delivered with one end of the iDDC satellite cable
already connected to the upper circuit board of the master unit and
one to the first satellite unit. The other end of each iDDC satellite
cable hangs out of the cable hole in the rear panel of the respec-
tive master unit or satellite unit.
To connect the iDDC cable, proceed as follows:
Procedure
1.
Unscrew the three cross-head screws (M4x8) on the right side
of the rear panel of the housing(s).
2.
Swing open the rear panel(s).
3.
Plug the connector into the lower circuit board(s) (according to
the illustration).
4.
Close the rear panel(s).
5.
Re-tighten the cross-head screws.
