![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374228.webp)
Standard function blocks
224
02/16 MN05013001Z EN
The contact of the function block is sent to markers.
Parameters
When using the function block in the circuit diagram for the
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
The parameters consist of the following:
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
“Parameter assignment from the standard circuit diagram”
on page 161.
This parameter is factory set to +.
Inputs
The signals at function block inputs >I1 and >I2 are
compared.
CP12 +
>I1
>I2
CP12
Function block: Data block comparator, number 12
+
Parameter display: Call enabled
>I1
First value
>I2
Second value
Parameters
Function
+
Parameters are displayed
-
Parameters are not displayed
Parameters
Function, parameterisation in the function
block
>I1
Comparison value 1: -2147483648 -
+2147483647
>I2
Comparison value 2: -2147483648 -
+2147483647
Содержание easySafety
