![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374030.webp)
ea
s
ySafety
26
02/16 MN05013001Z EN
Lines 1 and 4: Inputs/outputs
Line 1 shows the status of the basic unit inputs.
Line 4 shows the basic devices outputs and their operating
mode (RUN, STOP or BUSY).
section “easySafetyoperating modes”, Page 79.
Line 2: System information, diagnostics
You can change the content of line 2 (and 3) by pressing
ALT
.
After the initial power up, the easySafety device
indicates with P- that the cursor buttons (P buttons) are not
active and therefore cannot be used as button inputs in the
standard circuit diagram. Active P buttons are indicated with
P+ (
section “Activating and deactivating the P
buttons”, Page 590). The easySafety device will show
further system information in line 2 (
display additional information”, Page 29) depending on the
parameters and the peripheral devices connected.
Starting from the initial status display, you can press ALT
twice to show the following diagnostics messages in line 2
and 3:
• Line 2: status of the local diagnostics bits ID1...ID9 and P-
/+.
• Line 3: status of the local diagnostics bits I10...I16 as well
as R15 and R16
IS12..5.789...14
P-
MO 11:50
QR1
QS1..4 STOP
IS12..5.789...14
P-
MO 11:50
QR1 QS1..4
STOP
IS12..5.789....14
ID 1.......9 P-
ID10.....16 R..
QR1
QS1..4 STOP
ALT
2 x
Содержание easySafety
