![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374389.webp)
FS, safety foot switch
385
02/16 MN05013001Z EN
Parameters
When using the function block in the circuit diagram for the
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
The parameters consist of the following:
Enable
The Enable parameter specifies whether an external function
block enable is required. Further information can be found at
section “Enable parameter, EN enable coil” on page 345.
This parameter is factory set to NEN, the function block is
active without an external enable.
Evaluation
The parameter sets the function block for monitoring foot
switches with two or 4 break contacts.
easySafety is defined with a default setting for 4-channel
evaluation.
FS01 NEN *** *
*** 4CH
>ED OFF
FS01
Safety foot switch function block, No. 01
NEN
Enable: None required
4CH
Number of switch channels: 4 channels
>ED
Enable time: OFF (no monitoring time active).
Parameters
Function, parameterisation in the func-
tion block
EN
External enable required
NEN
No external enable required
Parameters
Function, parameterisation in the func-
tion block
2CH
2-channel evaluation
4CH
4-channel evaluation
Содержание easySafety
