![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374602.webp)
ea
s
ySafety Settings
598
02/16 MN05013001Z EN
Setting retentive behaviour
Requirement:
easySafety must be in STOP mode.
X
Switch to the system menu.
The factory setting of easySafety is for retentive actual
values. If easySafety is in STOP mode or the power supply is
switched of, all actual values are cleared.
X
Switch to STOP mode.
X
Switch to the system menu.
X
Enter the system menu via STD PARAMETERS and then on
to the RETENTION… menu.
X
Press the OK button.
The first screen that appears is a selection dialog for operand
marker bytes (MB). The display on the lower right
B:200
indicates the number of free bytes.
X
Use
ÍÚ
to select the operand.
X
Press OK to access the Entry modes.
–
ú í
Select position from to,
–
ÍÚ
Set a value.
h
Caution!
The retentive data is stored every time the power supply is
switched off and read when the power supply is switched
on. The data security of the memory is guaranteed for 10
10
write-read cycles.
h
If easySafety is password protected, the system menu
cannot be accessed until easySafety has been unlocked
(
RUN MODE
å Æ
DEBOUNCE..
DISPLAY...
RETENTION...
MB 00 -> MB 00
Æ
C 00
-> C
00
DB 00 -> DB 00
æ
B:200
Содержание easySafety
