![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374534.webp)
ea
s
yNet network
530
02/16 MN05013001Z EN
• Via keypad and display directly on the device. In this case
move to the system menu and select here the SAFETY ID
menu.
• Via MFD-CP4…/CP8… in TERMINAL MODE if this is
directly connected to the safety control relay.
• Via easySoft-Safety if the safety control relay to be
parameterised is directly connected to the PC via a
programming cable and the Local setting is selected in the
Communication View.
Commissioning NET
stations
Requirements for commissioning the NET:
• All stations must be properly connected to the NET
section “Connecting network ea
the bus terminating resistors on the physically first and last
NET stations must be fitted and the power supply must be
connected to all NET stations. The POW LED of all NET
stations must be lit or flashing.
• As the first NET station, use a device with a display.
• The device to be parameterised must be in STOP mode.
The POW LED of this NET station must be permanently lit.
When commissioning for the first time, the NET LED is “Off”.
h
Your NET can only be configured by the station with NET-
ID 1 if it has been set up according to the "loop-through"
(
page 65) topology. In order to simplify the process,
you should define all parameters through this NET station
with NET-ID 1.
Содержание easySafety
