![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374471.webp)
SG, safety gate (optionally
with guard locking)
467
02/16 MN05013001Z EN
Parameters
When using the function block in the circuit diagram for the
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
The parameters consist of the following:
Enable
The enable coil SG..EN allows the selective activation or
deactivation of the function block. Further information can
be found at section “Enable parameter, EN enable coil” on
page 345.
This parameter is factory set to NEN, the function block is
active without an external enable.
Operating mode
After easySafety has determined the conditions for safe
operation, there are different kinds of restarts possible. They
are described in greater detail as operating modes in chapter
“Operating mode parameter, RE reset coil” on page 346.
SG01 NEN MST *
OFF 2CH
>DT
3.0s
SG01
Function block: Safety gate, No. 01
NEN
Enable: none required
MST
Operating mode: Manual start
OFF
Startup test: deactivated
2CH
Evaluation: 2-channel
>DT
Discrepancy time: 3.0 seconds
Parameters
Function, parameterisation in the func-
tion block
EN
External enable required
NEN
No external enable required
Содержание easySafety
