Eaton easySafety, Руководство пользователя

Страница: 175 / 695

Working with function blocks
171
02/16 MN05013001Z EN
Checking function blocks
Requirement for the check: The easySafety device must be in
RUN mode.
Checking safety function blocks
You can check safety function blocks using the safety circuit
diagram.
X
In the circuit diagram, position the cursor on the required
safety function block in a contact or coil field.
X
Press OK.
The function block is shown, in this case a safety timing
relay.
• >T1= time value 1, set time 1 of the safety timing relay.
• >T2= time value 2, set time 2 of the safety timing relay.
X
Press ESC to return to the display of the safety circuit
diagram.
X
To leave the check display, press ESC once more and press
OK in answer to the subsequent CANCEL prompt.
Checking standard function blocks
You can check standard function blocks via the function
block editor.
Choose STANDARD -> PROGRAM... -> FUNCTION RELAYS
to enter the function block list which shows the standard
function blocks used.
X
In the function block list select the required standard
function block.
In this example, select the data block comparator AR01 in
Adder mode.
X
Press OK.
TS01 S X *
*** ***
>T1 022,000
>T2 011,000
AR01 ADD +
CP10 +
T 18 ?X
-
L:001 RUN