![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374278.webp)
Standard function blocks
274
02/16 MN05013001Z EN
Parameters
When using the function block in the circuit diagram for the
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
The parameters consist of the following:
Operating mode
The mode setting allows you to set whether markers,
outputs or both are to be reset.
This parameter is factory set to Q.
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
“Parameter assignment from the standard circuit diagram”
on page 161.
This parameter is factory set to +.
MR16 Q +
MR16
Function block: Master reset, number 16
Q
Mode: Reset outputs
+
Parameter display: Call enabled
Parameters
Function
Q
Resets the outputs used in the standard circuit
diagram, S.., *S.., *SN..;
* = NET-ID
M
Acts on the marker range MD01 to MD96.
ALL
Acts on the operands specified above under Q
and M that are used in the standard circuit
diagram.
Parameters
Function
+
Parameters are displayed
-
Parameters are not displayed
Содержание easySafety
