![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374180.webp)
Standard function blocks
176
02/16 MN05013001Z EN
Operating mode
This parameter defines which comparison result is to be used
to close function block contact Q1.
The factory setting of this parameter is LT.
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
“Parameter assignment from the standard circuit diagram”
on page 161.
This parameter is factory set to
+
.
Inputs
The signals at function block inputs >I1 and >I2 are
compared.
If required adjust the comparison values and increase them
by entering gain factors >F1 and >F2.
• >F1 is permanently assigned to >I1.
• >F2 is permanently assigned to >I2.
Parameters
Function, parameterisation in the function
block
GT
>I1 greater than >I2
EQ
>I1 equal to >I2
LT
>I1 less than >I2
Parameters
Function
+
Parameters are displayed
-
Parameters are not displayed
Parameters
Function
>I1
Comparison value 1: -2147483648 -
+2147483647
>I2
Comparison value 2: -2147483648 -
+2147483647
Содержание easySafety
