![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374171.webp)
Working with function blocks
167
02/16 MN05013001Z EN
Changing standard function block parameters
Parameters of the standard function blocks that you use in
the standard circuit diagram can be changed with the
following accesses:
• Access 1 - FUNCTION RELAYS, STOP mode
All parameters can be set or deleted via STANDARD ->
PROGRAM -> FUNCTION RELAYS and the function block
editor.
• Access 2- FUNCTION RELAYS menu, RUN mode
You access the function block editor via STANDARD ->
PROGRAM... -> FUNCTION RELAYS. Here you can change
set values (constants). This access is blocked on a
password-protected program.
• Access 3- PARAMETERS menu option, RUN mode
Choose STANDARD -> PARAMETERS to change the set
values (constants). These modification options are also
provided if you have saved the program and therefore
password protected the function block editor. With the
standard function blocks uses you can use the +/-
character to set which function blocks allow the changing
of their parameters.
Access 1 -
FUNCTION RELAYS
, STOP mode
This access method is basically no different to the initial
parameter assignment of a standard function block
(
section “Parameter assignment from the standard
Access 2 -
FUNCTION RELAYS
, RUN mode
Requirements for the parameter setting via STANDARD -
>FUNCTION RELAYS:
• The standard function block is used in the standard circuit
diagram or function block.
• Access to the parameter set is enabled, indicated by the +/
- character at the top right of the display.
Proceed as follows to call the parameter dialog again for
changes:
X
Press OK to switch to the main menu.
Содержание easySafety
