![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374533.webp)
Introduction to the ea
s
yNet
network
529
02/16 MN05013001Z EN
Transfer of the standart- and safety circuit diagram
via the NET
From easySoft-Safety, the safety configuration can be
transferred (PC => Device/Device => PC), compared (PC =
Device ?) and deleted via the NET.
With this configuration you access via the NET the target
device via the NET station that is connected to the PC with a
programming cable. The NET provides this routing function
automatically under the following conditions.
• The NET must be configured correctly and be in operation.
• The easySafety must have been assigned a safety ID (SID).
Safety ID (SID1 - SID8)
You can also transfer the safety circuit diagram from
easySoft-Safety to the target device via the NET.
To do this, you must assign a safety ID to the target device.
This safety ID identifies it uniquely and reliably as the
receiver of the safety configuration. For the transfer, the
values of the safety ID on the safety control relay and in the
easySoft-Safety project must coincide.
The safety ID is permanently assigned to the safety control
relay and is also retained if, for example, the device is given
another position or NET ID in the NET.
The safety ID is a property of the device and does not have
to be the same as the NET ID (although this recommended).
It is not password protected and is not part of the
configuration. You assign the safety ID in the following way:
h
A safety configuration consists of the safety circuit
diagram, a possible standard circuit diagram (incl. the
function block diagram in each case) and the safety
settings.
Содержание easySafety
