![background image](http://html1.mh-extra.com/html/eaton/easysafety/easysafety_manual_3958374400.webp)
Safety function blocks
396
02/16 MN05013001Z EN
The parameters consist of the following:
Enable
The Enable parameter specifies whether an external function
block enable is required. Further information can be found at
section “Enable parameter, EN enable coil” on page 345.
This parameter is factory set to NEN, the function block is
active without an external enable.
Operating mode
After easySafety has determined the conditions for safe
operation, there are different kinds of restarts possible. They
are described in greater detail as operating modes in section
“Operating mode parameter, RE reset coil” on page 346.
The factory setting of this parameter is MST, Manual Start.
LC01
Function block: light curtain, number 01
NEN
Enable: None required
MST
Operating mode: Manual start
OFF
Startup test: deactivated
>DT
Discrepancy time: 3.0 seconds
Parameters
Function, parameterisation in the func-
tion block
EN
External enable required
NEN
No external enable required
Parameters
Function, parameterisation in the func-
tion block
AST
Automatic start, no manual restart
MST
Manual start
CST
Controlled start
Содержание easySafety
