ea
s
ySafety operation
29
02/16 MN05013001Z EN
Status display additional information
Depending on the additional parameters set (e.g. retentive
operands) or the connected peripheral devices (e.g. when
running as an easyNet station) the system information listed
below is also shown in the status display.
Retention/Debounce/
easyNet station
AC expansion ok/P buttons off
Startup behaviour
RE
: Retention switched on
RS
: Local expansion operating correctly
I
: Debounce switched on
NT1
: easyNET station with Net-ID (1 in this case)
AC
: AC expansion functioning correctly
DC
: DC expansion functioning correctly
GW
: Bus coupling module detected
GW flashes: Only easy200-easy detected. I/O expansion not detected.
ST
: When the power supply is switched on, the easySafety switches to STOP mode
IS12...6.89.....
RE
I NT1 AC P-
MO 11:50 T
QR1 QS1..4
RUN
Содержание easySafety
