Chevrolet BEAUVILLE SPORTVAN G10 SERIES, Руководство по обслуживанию

Страница: 65 / 350

BODY 1B-18
Fig. 3 8 —Loosening W eatherstrip
Installation
1. A tta ch leg and su p p o rt assem bly to seat. T o rq u e to
specifications.
2. A tta c h seat belts. T o rq u e b olts to specifications.
C A U T IO N : Shoulder o f b olt must b o tto m on
weld nut.
2. F rom inside vehicle apply pressure w ith palm o f h and to
b o tto m o f glass and assist th e lip o f the w eatherstrip over
the flange w ith a flat bladed tool as show n in (Figure 38).
With aid o f helper to hold w indow , continue moving
w eatherstrip over flange un til w indow is o u t o f opening.
3. Rem ove w eatherstrip from glass, and remove reveal m o ld ­
ings from w eatherstrip if so equipped.
4. Clean flange in bo d y opening.
Installation
1. Install reveal m oldings into w eatherstrip (if so equipped).
2. Install w eatherstrip o n to windshield.
3. Wrap a piece o f heavy string or cord around circum fer­
ence o f the w eatherstrip leaving a loop at the to p and th e
loose ends at the b o tto m (Fig. 39).
4. Place glass in to opening. With one technician lightly
pushing in on glass, an o th er technician inside should pull
the cord as follows:
a.
Pull on loose ends (Fig. 40 ) until each is w ithin 2 "
o f respective corner.
b. Finish seating corners by sim ultaneously pulling on
b o th ends o f th e cord at each corner.
3. A ttach seat to floor. T o rq u e bolts to specifications.
BODY WINDOWS
Side Stationary Window Glass,
Weatherstrip and Reveal Moldings
Removal
1. F rom inside vehicle loosen w eatherstrip from flange.
N O T E : If equipped w ith reveal molding, do not
a tte m p t to remove moldings w hile glass is in body
opening. The moldings can only be removed after
removal o f glass.
Side Window Glass and Hinge-Swingout
(Fig. 41)
Removal
1. Swing o u t w indow.
2. Rem ove screws retaining latch to body.
3. Rem ove w indow hinge retaining screws and window .
4. Rem ove latch from glass.
Installation
1
. Install latch to glass using escutcheon, spacer, washer,
latch and screw. T orque to specifications.
2. Place w indow into opening and install hinge retaining
screws and window .
3. Install latch to glass.
LO O P CORD
AT TOP
Fig. 3 9 —Cord Installation (T ypical) Fig. 4 0 —Pulling String to Seal R ubber Lip
------
C H E V Y V A N S H O P M A N U A L