ENG IN E FUEL 6M-3
HOLD DOWN ON
CHOKE VALVE
GAUGE BETWEEN CHOKE
VALVE AND AIR HORN WALL
BEND ROD TO ADJUST
CAM FOLLOWER MUST BE
HELD FIRM LY ON SECOND
STEP OF FAST IDLE CAM
AGAINST HIGH STEP
CH OK E R O D (FAST IDLE C A M ) A D JU STM EN T
ROD IN END
OF SLOT
Fig. 4 C —C hoke Rod (Fast Idle Cam) A djustm ent (M V )
M anual choke m odels w ith sm o o th co n to u r cam. Use the
same procedure as above except for S tep 1.
As there are no steps on m anual choke cam , the index line
on side o f cam should be lined up w ith c o n tac t p o in t o f the
fast idle cam follow er tang.
2G V (Fig. 5C)
T urn sto p screw in u n til it ju s t contacts b o tto m step o f fast
idle cam . T hen tu rn screw in one full tu rn . Place idle screw on
second step o f fast idle cam against shoulder o f high step. With
screw in this p o sitio n , h o ld choke valve to w ard closed position
w ith a ru b b er b an d and check clearance betw een upper edge o f
choke valve and air ho rn wall. A djust to specified dim ension
by bending tang on choke lever and collar assembly.
4M V (Fig. 6C)
W ith the cam follow er on second step o f fast idle cam and
against th e high step, ro ta te th e choke valve tow ard th e closed
Fig. 5C —Choke Rod (Fast Idle Cam) A djustm ent (2 G V )
position b y turn in g th e external choke lever counterclockw ise.
D im ension betw een the low er edge o f choke valve, a t choke
lever en d , should be as specified. Bend choke ro d to adjust
(Fig.
6
C).
CHOKE VA C U U M BREAK ADJUSTMENTS
(M V) (Fig. 7C)
The follow ing procedure for adjusting th e vacuum break
diaphragm unit is used to insure correct initial choke valve
opening after engine starting:
1. Rem ove air cleaner assem bly fro m vehicle. On vehicles
w ith “ T herm AC” air cleaner, plug the sensor’s vacuum
tak e-o ff p o rt.
2. Using an outside vacuum source, apply vacuum to the
vacuum b reak diaphragm until th e plunger is fully seated.
3. W ith the vacuum b rea k diaphragm in th e fully seated
p osition, push th e choke valve tow ard the closed
position.
Fig. 7 C —V acuum Break A djustm ent (M V )
C H E V Y V A N S H O P M A N U A L
*
Содержание BEAUVILLE SPORTVAN G10 SERIES
