ZyXEL Communications XS3800-28, User Manual, Page: 728 / 789

Chapter 88 Networked AV Mode
XS3800-28 User’s Guide
728
88.29.2 Add IGMP Filtering Rule
Click Add Rule in the SWITCHING > Multicast > IGMP Filtering Profile screen to access this screen.
Figure 580 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
The following table describes the labels in this screen.
88.30 VLAN
This section shows you how to configure 802.1Q tagged and port-based VLANs.
88.30.1 What You Can Do
• Use the VLAN Status screen ( Section 88.31 on page 731 ) to view and search all static VLAN groups.
• Use the VLAN Detail screen ( Section 88.31.1 on page 732 ) to view detailed port settings and status of
the static VLAN group.
• Use the Static VLAN screen ( Section 88.32 on page 733 ) to configure a static VLAN for the Switch.
• Use the VLAN Port Setup screen ( Section 88.33 on page 736 ) to configure the static VLAN (IEEE 802.1Q)
settings on a port.
88.30.2 What You Need to Know
Read this section to know more about VLAN and how to configure the screens.
Table 394 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
LABEL DESCRIPTION
Profile Name Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
End Address Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the
Start
Address and End Address fields.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.