ZyXEL Communications XS3800-28, User Manual, Page: 675 / 789

Chapter 87 MAINTENANCE
XS3800-28 User’s Guide
675
The following table describes the labels in this screen.
87.11 Erase Running-Configuration
Follow the steps below to clear current configuration on the Switch. Note that this will NOT reset the
Switch back to its factory defaults. For example, if your Switch is set to Stacking mode and you click
erase running-configuration, after the Switch restarts, it will remain in Stacking mode. If you want to
change the Switch to its factory default Standalone mode, click the
Factory Default button in
MAINTENANCE > Reboot System .
Table 364 MAINTENANCE > Configuration > Auto Configuration
LABEL DESCRIPTION
Use this section to view the auto configuration status after you restarted the Switch.
Mode This field shows the mode ( DHCP or HTTPS ) that is used for auto configuration after you enabled
auto configuration and restarted the Switch.
It shows None if auto configuration was not enabled.
State This field shows whether auto configuration was executed successfully the last time the Switch
rebooted.
None – Auto configuration was disabled and not executed.
Success – An auto configuration file was downloaded successfully to the Switch.
Un-success – An auto configuration file was not downloaded to the Switch.
Filename This field displays the name of the auto configuration file that was downloaded the last time the
Switch rebooted.
It shows blank if auto configuration was not enabled or not executed successfully.
Use this section to enable auto configuration and select the mode that you want to use for auto configuration.
Active Enable the switch button to enable auto configuration.
Mode Select DHCP to have the Switch use the TFTP server IP address and auto configuration file name
assigned by a DHCP server to download a pre-saved configuration file when the Switch
reboots.
Note: The Switch should act as a DHCP client to send a DHCP request with DHCP
option 60 so that it can get the TFTP server address and configuration file name
from the DHCP server.
Select HTTPS to have the Switch use the URL you specified in the HTTPS URL field to access a web
server and download the auto configuration file using HTTPS.
DHCP VLAN ID Enter the VLAN ID of the DHCP server that assigns the TFTP server IP address and auto
configuration file name to the Switch.
HTTPS URL Type the URL that can be used to access and download the auto configuration file from a web
server using HTTPS. For example, https://webserverIPaddress/configfilename.cfg.
Note: You must fill in this field if you select HTTPS in the Mode field. Otherwise, auto
configuration will not work.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.