ZyXEL Communications XS3800-28, User Manual, Page: 164 / 789

Chapter 23 IP Setup
XS3800-28 User’s Guide
164
Figure 106 SYSTEM > IP Setup > Network Proxy Configuration
The following table describes the labels in this screen.
Table 49 SYSTEM > IP Setup > Network Proxy Configuration
LABEL DESCRIPTION
Active Enable the switch button to enable communication between the Switch and NCC through a
proxy server.
Server Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the
Server except [ ? ], [ | ],
[ ' ], or [ " ].
Port Enter the port number of the proxy server (1 – 65535).
Authentication Enable the switch button to enable proxy server authentication using a Username and
Password .
Username Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the
Username except [ ? ], [ | ], [ ' ], or [ " ].
Password Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the
Password except [ ? ], [ | ], [ ' ], or [ " ].
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.