ZyXEL Communications XS3800-28, User Manual, Page: 352 / 789

Chapter 47 PPPoE
XS3800-28 User’s Guide
352
47.5 PPPoE IA VLAN
Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN and whether the
Switch appends the Circuit ID and/or Remote ID to PPPoE discovery packets from a specific VLAN.
Click SWITCHING > PPPoE Intermediate Agent > PPPoE IA VLAN to display the screen as shown.
Figure 262 SWITCHING > PPPoE Intermediate Agent > PPPoE IA VLAN
The following table describes the labels in this screen.
Table 167 SWITCHING > PPPoE Intermediate Agent > PPPoE IA VLAN
LABEL DESCRIPTION
Show VLAN
Use this section to specify the VLANs you want to configure in the section below.
Start VID Enter the lowest VLAN ID you want to configure in the section below.
End VID Enter the highest VLAN ID you want to configure in the section below.
Apply Click Apply to display the specified range of VLANs in the section below.
VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure the *
VLAN, the settings are applied to all VLANs.
* Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Changes in this row are copied to all the VLANs as soon as you make them.
Enabled Select this option to turn on the PPPoE Intermediate Agent on a VLAN.
Circuit-ID Select this option to make the Circuit ID settings for a specific VLAN take effect.
Remote-ID Select this option to make the Remote ID settings for a specific VLAN take effect.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.