ZyXEL Communications XS3800-28, User Manual, Page: 254 / 789

Chapter 35 Link Layer Discovery Protocol (LLDP)
XS3800-28 User’s Guide
254
35.9 LLDP-MED Network Policy
Click PORT > LLDP > LLDP MED > LLDP-MED Network Policy to display the screen as shown next.
Figure 175 PORT > LLDP > LLDP MED > LLDP-MED Network Policy
The following table describes the labels in this screen.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location Select to enable transmitting LLDP-MED location TLV.
Network Policy Select to enable transmitting LLDP-MED Network Policy TLV.
Apply Click Apply to save the changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 109 PORT > LLDP > LLDP > LLDP-MED Setup (continued)
LABEL DESCRIPTION
Table 110 PORT > LLDP > LLDP MED > LLDP-MED Network Policy
LABEL DESCRIPTION
Index This field displays the of index number of the network policy. Click an index number to edit
the rule.
Port This field displays the port number of the network policy. In Stacking mode, the first number
represents the slot and the second the port number.
Application Type This field displays the application type of the network policy.
Tag This field displays the Tag Status of the network policy.
VLAN This field displays the VLAN ID of the network policy.
DSCP This field displays the DSCP value of the network policy.
Priority This field displays the priority value of the network policy.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new schedule rule or edit a selected one.
Delete Select the rules that you want to remove, then click Delete .