ZyXEL Communications XS3800-28, User Manual, Page: 511 / 789

Chapter 67 OSPF
XS3800-28 User’s Guide
511
67.5 Configuring IPv4 OSPF Redistribution
Use this screen to configure route redistribution and summary addresses. Route redistribution is used
when other routers which use RIP routing protocol and/or static routes and/or connected routes need to
exchange routing information with the Switch using OSPF routing protocol. These routes are called
external routes. A summary address is used to cover more than one routing entries in order to reduce the
routing table size.
Click NETWORKING > OSPF > IPv4 OSPF > OSPF Redistribution to display the following screen.
Figure 405 NETWORKING > OSPF > IPv4 OSPF > OSPF Redistribution
Hello Interval Specify how often (in seconds) the Switch sends hello packets on the interface to check if the
interface's neighbor devices still exist. The valid range for hello interval is between 1 and 65535.
The default value is 10 seconds.
Dead Interval Specify how long (in seconds) the Switch should wait for a hello packet from the interface's
neighbor device before declaring that the neighbor device is not available. The valid range for
dead interval is between 1 and 65535. The default value is 40 seconds.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 270 NETWORKING > OSPF > IPv4 OSPF > OSPF Interface > Add/Edit (continued)
LABEL DESCRIPTION