ZyXEL Communications XS3800-28, User Manual, Page: 424 / 789

Chapter 57 VLAN
XS3800-28 User’s Guide
424
57.7 Configure GVRP
Use this screen to configure GVRP settings on a port. Click SWITCHING > VLAN > VLAN Setup > GVRP to
display the screen as shown.
Figure 319 SWITCHING > VLAN > VLAN Setup > GVRP (Standalone Mode)
Acceptable
Frame Type Specify the type of frames allowed on a port. Choices are All , Tag Only and Untag Only .
Select All from the drop-down list box to accept all untagged or tagged frames on this port.
This is the default setting.
Select Tag Only to accept only tagged frames on this port. All untagged frames will be
dropped.
Select Untag Only to accept only untagged frames on this port. All tagged frames will be
dropped.
Note: When the Switch is in Stacking mode and the master Switch has VLAN1, all
other ports will be configured to untagged port.
VLAN Trunking Enable VLAN Trunking on ports connected to other switches or routers (but not ports directly
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the Switch.
Isolation Select this to allows this port to communicate only with the CPU management port and the
ports on which the isolation feature is NOT enabled.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 204 SWITCHING > VLAN > VLAN Setup > VLAN Port Setup (continued)
LABEL DESCRIPTION