ZyXEL Communications XS3800-28, User Manual, Page: 135 / 789

Chapter 15 Path MTU Table
XS3800-28 User’s Guide
135
Figure 87 MONITOR > Port Status > Port Utilization (Stacking Mode)
The following table describes the labels in this screen.
Table 34 MONITOR > Port Status > Port Utilization
LABEL DESCRIPTION
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number of the
Switch in a stack.
Port This identifies the Ethernet port. In Stacking mode, the first number represents the slot ID and the
second is the port number. Please note that the default stacking ports (the last four ports of your
Switch) cannot be configured. They are reserved for stacking only.
Link This field displays the speed (either 100M for 100Mbps, 1G for 1 Gbps, 2.5G for 2.5 Gbps, 5G for 5
Gbps, or 10G for 10 Gbps) and the duplex ( F for full duplex or H for half). It also shows the cable
type ( Copper or Fiber ) for the combo ports. This field displays Down if the port is not connected to
any device.
Tx kB/s This field shows the transmission speed of data sent on this port in kilobytes per second.
Tx Utilization% This field shows the percentage of actual transmitted frames on this port as a percentage of the
Link speed.
Rx kB/s This field shows the transmission speed of data received on this port in kilobytes per second.
Rx Utilization% This field shows the percentage of actual received frames on this port as a percentage of the Link
speed.