ZyXEL Communications XS3800-28, User Manual, Page: 296 / 789

Chapter 43 Mirroring
XS3800-28 User’s Guide
296
The following table describes the labels in this screen.
43.3.1 Add/Edit Remote Port Mirroring
Use this screen to create or edit a remote port mirroring (RMirror) VLAN through which the mirrored traffic
is forwarded.
Click Add/Edit , or select an entry and click Add/Edit in the SWITCHING > Mirroring > RMirror screen to
display this screen.
Figure 209 SWITCHING > Mirroring > RMirror > Add/Edit
The following table describes the labels in this screen.
43.4 Source
Use this screen to configure the reflector port and specify the traffic flow to be copied to the monitor
port when the Switch is the source device in remote port mirroring.
Click SWITCHING > Mirroring > RMirror > Source to display the screen as shown.
Table 125 SWITCHING > Mirroring > RMirror
LABEL DESCRIPTION
VLAN This field displays the ID number of the RMirror VLAN.
Active This field displays whether the VLAN is enabled or not.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 126 SWITCHING > Mirroring > RMirror > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to enable the VLAN.
RMirror VLAN ID Specify the ID number of remote port mirroring (RMirror) VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.