ZyXEL Communications XS3800-28, User Manual, Page: 161 / 789

Chapter 23 IP Setup
XS3800-28 User’s Guide
161
Figure 103 SYSTEM > IP Setup > IP Setup
The following table describes the labels in this screen.
Table 47 SYSTEM > IP Setup > IP Setup
LABEL DESCRIPTION
IP Setup
Default
Gateway Type the IP address of the default outgoing gateway in dotted decimal notation, for example
192.168.1.254.
Domain Name
Server 1/2 Enter a domain name server IPv4 address in order to be able to use a domain name instead of
an IP address.
Default
Management Specify which traffic flow ( In-band or Out-of-band ) the Switch is to send packets originating
from itself (such as SNMP traps) or packets with unknown source.
Select Out-of-band to have the Switch send the packets to the management port labeled
MGMT . This means that devices connected to the other ports do not receive these packets.
Select In-band to have the Switch send the packets to all ports except the management port
(labeled MGMT ) to which connected devices do not receive these packets.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Out-of-band Management IP Address
Use these fields to set the settings for the out-of-band management port.
IP Address Enter the out-of-band management IP address of your Switch in dotted decimal notation. For
example, 192.168.0.1.