ZyXEL Communications XS3800-28, User Manual, Page: 466 / 789

Chapter 63 ARP Setup
XS3800-28 User’s Guide
466
63.3.1 Add/Edit Static ARP
Use this screen to add/edit static ARP entries. Click Add/Edit , or select an entry and click Add/Edit in the
NETWORKING > ARP Setup > Static ARP to display this screen.
Figure 359 NETWORKING > ARP Setup > Static ARP > Add/Edit (Standalone Mode)
Figure 360 NETWORKING > ARP Setup > Static ARP > Add/Edit (Stacking Mode)
The following table describes the related labels in this screen.
Table 233 NETWORKING > ARP Setup > Static ARP > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Name Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ])
for identification purposes.
IP Address Enter the IP address of a device connected to a Switch port with the corresponding MAC
address below.
MAC Address Enter the MAC address of the device with the corresponding IP address above.
VID Enter the ID number of VLAN to which the device belongs.
Port Enter the number of port to which the device connects. In Stacking mode, the first field is the
slot ID and the second field is the port number.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.