ZyXEL Communications XS3800-28, User Manual, Page: 687 / 789

Chapter 87 MAINTENANCE
XS3800-28 User’s Guide
687
Figure 548 MAINTENANCE > Reboot System (Stacking Mode)
1
Click the Config 1 , Config 2 , Factory Default , or Custom Default (or Stacking Default in Stacking mode)
button to reboot and load that configuration file. The confirmation screen displays.
Figure 549 Reboot Confirmation
2
Click YES and then wait for the Switch to restart. This takes up to 2 minutes.
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Stacking Default and follow steps 1 to 2 to reboot and load stacking default configuration settings
on the Switch. The master Switch login information will not be reset.
Click Factory Default and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
settings on the Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load a customized default file on the Switch.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2 .
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.
87.17 Service Register
Switch requires a license to use certain services. You can register your Switch and manage Switch
licenses at www.myzyxel.com.
See Table 1 on page 31 for the new services supported when you purchase a Basic Routing License.
Note: You can configure licensed features without a license, but the features will not work.
Click MAINTENANCE > Service Register to display the screen as shown. Use this screen to display the
status of your service registration. Go to myZyxel to activate the subscription.