ZyXEL Communications XS3800-28, User Manual, Page: 535 / 789

Chapter 72 VRRP
XS3800-28 User’s Guide
535
72.3.4 Add/Edit VRRP Parameters
After you set up an IP interface, view and configure the VRRP parameters in the VRRP Setup screen.
Click Add/Edit , or select an entry and click Add/Edit in the lower section in the NETWORKING > VRRP >
VRRP Setup screen to display this screen.
Figure 424 NETWORKING > VRRP > VRRP Setup: VRRP Parameters > Add/Edit
The following table describes the labels in this screen.
Table 289 NETWORKING > VRRP > VRRP Setup: VRRP Parameters > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to enable this VRRP entry.
Name Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or
[ , ]) for identification purposes.
Network Select an IP domain to which this VRRP entry applies.
Virtual Router ID Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
Advertisement Interval
(s) Specify the number of seconds between Hello message transmissions. The default is 1 .
Preempt Mode Select this option to activate preempt mode.
Priority Enter a number (between 1 and 254) to set the priority level. The bigger the number, the
higher the priority.
This field is 100 by default.
Uplink Gateway Enter the IP address of the uplink gateway in dotted decimal notation.
The Switch checks the link to the uplink gateway.
Response Ping Select this option to have the Switch respond to a ping that is sent to the virtual IP address.
Primary Virtual IP Enter the IP address of the primary virtual router in dotted decimal notation.
Secondary Virtual IP This field is optional. Enter the IP address of a secondary virtual router in dotted decimal
notation. This field is ignored when you enter
0.0.0.0 .