ZyXEL Communications XS3800-28, User Manual, Page: 733 / 789

Chapter 88 Networked AV Mode
XS3800-28 User’s Guide
733
Figure 585 SWITCHING > VLAN > VLAN Status > VLAN Status Details
The following table describes the labels in this screen.
88.32 Configure a Static VLAN
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified
VID.
Use this screen to view and configure a static VLAN for the Switch. Click SWITCHING > VLAN > Static
VLAN to display the screen as shown next.
Table 397 SWITCHING > VLAN > VLAN Status > VLAN Status Details
LABEL DESCRIPTION
VID This is the VLAN identification number that was configured in the corresponding VLAN
configuration screen.
Elapsed Time This field shows how long it has been since a normal VLAN was registered or a static VLAN was
set up.
Status This field shows how this VLAN was added to the Switch.
• Dynamic – using GVRP
• Static – manually added as a normal VLAN
• Private – manually added as a private VLAN (primary, isolated or community)
• RMirror – manually added as a remote port mirroring VLAN
• MVR – added through Multicast VLAN Registration (MVR)
Port Number This section displays the ports that are participating in a VLAN. A tagged port is marked as T , an
untagged port is marked as U and ports not participating in a VLAN are marked as “ – “.