4 - 13
ENG
CARBURETOR
Measurement and adjustment steps:
• Hold the carburetor in an upside down
position.
NOTE:
• Slowly tilt the carburetor in the opposite
direction, then take the measurement
when the needle valve aligns with the float
arm.
• If the carburetor is level, the weight of the
float will push in the needle valve, resulting
in an incorrect measurement.
• Measure the distance between the mating
surface of the float chamber and top of the
float using a vernier calipers.
NOTE:
The float arm should be resting on the nee-
dle valve, but not compressing the needle
valve.
• If the float height is not within specification,
inspect the valve seat and needle valve.
• If either is worn, replace them both.
• If both are fine, adjust the float height by
bending the float tab
b
on the float.
• Recheck the float height.
EC464600
Float
1. Inspect:
• Float
1
Damage
→
Replace.
Starter plunger
1. Inspect:
• Cold starter plunger
1
• Hot starter plunger
2
Wear/damage
→
Replace.
