Xerox ColorQube 9303 Series, Service Manual, Page: 964 / 1812

February 2013
4-206 ColorQube® 9303 Family
REP 12.61-171
Repairs/Adjustments
Replacement
CAUTION
Do not damage the harnesses when the BM module is installed. Ensure that the rails are cor-
rectly aligned with the slides.
1. Put the BM module on the paper stack in front of the HVF BM.
2. Route the bin 2 harness and the ground harness to the rear of the HVF BM.
3. If a new BM is to be installed, perform the following:
a. Unlatch the slides from the new BM module. Refer to Figure 5 .
b. Install the new BM module onto the existing rails in the HVF BM.
4. Figure 7 , prepare to install the BM module.
Figure 7 Position of the catch
5. Reverse the removal procedure to replace the BM module.
CAUTION
Ensure the BM harness and bin 2 harness are correctly positioned in the harness retainers so
that harnesses are not damaged when the BM is moved to the extremities of its travel.
6. Perform the 12D-171 Booklet Quality RAP.
1
Hold the catch in the forward position.
2
Carefully push the BM module into
the HVF BM until the catch is held
under the guide. Do not push the
BM further into HVF BM.
Guide