Xerox ColorQube 9303 Series, Service Manual

Page: 556 / 1812

February 2013
2-532 ColorQube® 9303 Family
OF 3
Status Indicator RAPs
Y N
Install new components as necessary.
Check the seven segment display on the single board controller PWB. The seven seg-
ment display the decimal point is flashing heart beat.
Y
N
Go to the
01C +3.3V Distribution RAP and check the +3.3V supply to the single
board controller PWB. If the +3.3V supply to the PWB is good install a new single
board controller PWB,
PL 3.11 Item 13 .
Check the connections to the hard disk drive, PL 3.11 Item 2 . If the connections are good
perform the actions that follow:
•
Reload the software, GP 4 .
• Install a new hard disk drive, PL 3.11 Item 2 .
NOTE: If a new hard drive is installed then the software will need to be reloaded.
The green progress screen is displayed.
Y
N
The display stays at the green ‘Xerox’ screen. Observe the LED’s on the IME controller,
Figure 2 . Perform the relevant action:
• If the green LED is blinking, reload the software, GP 4 .
• The single board controller is not booting or there is a communication problem
between the single board controller PWB and the IME controller PWB.
– Reboot in diagnostics state, GP 1 and refer to How to enter directly into service
mode. Enter dC123 PEST Fault History and dC122 Fault History. Review the
fault history then go to the indicated RAP.
– Check the power supplies to the power distribution PWB, single board control-
ler PWB, HDD, scanner, DADH PWB, finisher, tray 5 and 3 tray module.
Go to the relevant voltage distribution RAP:
01D +5V Distribution RAP.
01E +12V Distribution RAP.
01G +17V Distribution RAP
01H +24V Distribution RAP.
Check the connections to the single board controller, hard disk drive and harness PJ 5,
PL 3.11 Item 2 . If the connections are good perform the actions that follow:
• Harness hard disk drive / Single board controller PWB, PL 3.11 Item 3 .
• Reload the software, GP 4 .
• Install a new hard disk drive, PL 3.11 Item 2 .
NOTE: If a new hard drive is installed then the software will need to be reloaded.
Perform SCP 5 Final Actions.
Figure 1 Power LEDs
Green
Orange Red
E