Xerox ColorQube 9303 Series, Service Manual, Page: 375 / 1812

February 2013
2-351 ColorQube® 9303 Family
89-125-00 to 89-128-00, 89-130-00, 89-131-00, 89-
Status Indicator RAPs
NOTE: W/TAG 018 machines do not have air pumps install as standard. However, the preheat
air pumps in a replacement registration/preheat assembly will function when the unit is
installed, refer to service bulletin T8009-12-06
Enter dC330 code 88-008 registration / preheat air pumps, MOT88-008. Press Start. The air
pumps run.
Y
N
Go to
WD 8.6 . Check registration / preheat air pumps, MOT88-008. Refer to:
• GP 10 How to Check a Motor.
• PJ5, Registration / preheat IF PWB.
• 01E +12V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Registration / preheat air pumps, PL 88.10 Item 5 .
• Registration / preheat IF PWB, PL 88.10 Item 10 .
Check the registration transport for obstructions.
89-500-00, 89-502-00 Registration Motor Over Current RAP
89-500-00 Motor M3_A1 current demand is inconsistent with expected value.
89-502-00 Motor M3_A2 current demand is inconsistent with expected value.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP 14 . Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury
Check and clear the media path.
Procedure
Refer to Figure 1 . Enter dC330 and test the registration motors (MOT89-007 and MOT89-008).
Refer to GP 10 How to check a motor. The motors run.
Y N
Refer to
WD 8.1 . Check connections at PJ202 on the media path driver PWB . The con-
nections are good.
Y
N
Reseat connections to the registration motors and
registration / preheat interface
PWB . Check the bulkhead connector. Reseat the in-line connector to the chassis
bulkhead.
Check operation of the registration rollers when the motors are run. The rollers rotate.
Y
N
Check registration roller drive belts and drive gears for damage or debris.
If the fault persists, install a new registration / preheat assembly PL 88.10 Item 1 .
The fault may be intermittent, if the fault persists, install new components as necessary:
•
Registration / preheat assembly PL 88.10 Item 1 .
• Media path driver PWB, PL 1.15 Item 5 .
A