Xerox ColorQube 9303 Series, Service Manual

Page: 360 / 1812

February 2013
2-336 ColorQube® 9303 Family
82-161-00
Status Indicator RAPs
82-161-00 Early Confirm Timeout RAP
82-161-00 Early confirm timeout.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP 14 . Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check for obstructions in the tray 3 horizontal transport paper path.
• Check the tray 3 horizontal transport rolls.
Procedure
Enter dC330 code 73-397 TAR 3 Sensor, Q73-397, PL 81.35 Item 18 . Press Start. Pull out the
horizontal transport. Manually actuate the sensor by placing a piece of paper over the sensor
but not in the nip rolls. Push in the horizontal transport.
NOTE: Sensors Q73-397 and Q70-398 in the horizontal transport, have the same item num-
ber. Ensure you check the correct sensor.
The display changes.
Y
N
Go to
WD 7.4 . Check TAR 3 Sensor, Q73-397. Refer to:
• GP 11 How to Check a Sensor.
• PJ954, 3 tray module PWB
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• TAR 3 sensor, PL 81.35 Item 18 .
• 3 Tray Module PWB, PL 73.16 Item 4 .
Enter dC330 code 70-398 tray 3 transport sensor, Q70-398, PL 81.35 Item 18 . Press Start. Pull
out the horizontal transport. Manually actuate the sensor by placing a piece of paper over the
sensor but not in the nip rolls. Push in the horizontal transport.
NOTE: Sensors Q73-397 and Q70-398 in the horizontal transport, have the same item num-
ber. Ensure you check the correct sensor.
The display changes.
Y
N
Go to
WD 7.4 . Check tray 3 transport sensor, Q70-398. Refer to:
• GP 11 How to Check a Sensor.
• PJ954, 3 tray module PWB .
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Tray 3 transport sensor, PL 81.35 Item 18 .
• 3 Tray Module PWB, PL 73.16 Item 4 .
Enter dC330 code 70-025 3 tray transport motor, MOT70-025. Press Start. The motor runs.
Y N
Go to
WD 7.5 . Check 3 tray transport motor, MOT70-025. Refer to:
• GP 10 How to Check a Motor.
• PJ953, 3 tray module PWB .
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• 3 tray module transport motor, PL 73.16 Item 3 .
• 3 tray module PWB, PL 73.16 Item 4 .
The transport rolls rotate.
Y
N
Check the gears and drive belt,
PL 73.16 .
Perform the following:
• If the fault still occurs, check the grounding of the following, GP 7 :
– The takeaway roll assembly, PL 81.35 Item 16 .
– The transport roll 2 assembly, PL 81.35 Item 15 .
– The transport roll 1 assembly, PL 81.35 Item 14 .
A
A