Xerox ColorQube 9303 Series, Service Manual

Page: 94 / 1812

February 2013
2-70 ColorQube® 9303 Family
10-110-00 to 10-113-00, 10-125-00 to 10-128-00, 10-
Status Indicator RAPs
Install new components as necessary:
• Post transfix sensor (11), PL 10.10 Item 6 .
• Drum driver PWB, PL 1.15 Item 4 .
Enter dC330 code 10-016 pre exit sensor (12), Q10-016, PL 10.10 Item 6 . Manually actuate
Q10-016. The display changes.
Y
N
Refer to
WD 9.3 . Check the pre exit sensor (12), Q10-016. Refer to:
• GP 11 How to Check a Sensor.
• PJ801, Drum driver PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Pre exit sensor (12), PL 10.10 Item 6 .
• Drum driver PWB, PL 1.15 Item 4 .
Enter dC330 code 82-007 to energize the nip C release solenoid, SOL82-007, PL 82.15 Item
4 . SOL82-007 energizes.
Y N
Refer to
WD 8.1 . Check the nip C release solenoid, SOL82-007. Refer to:
• GP 12 How to Check a Solenoid or Clutch.
• PJ303, Media path driver PWB.
• 01J +50V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Nip C release solenoid, PL 82.15 Item 4 .
• Media path driver PWB, PL 1.15 Item 5 .
Enter dC330 code 82-008 to energize the nip D release solenoid, SOL82-008, PL 70.30 Item
13 , SOL82-008 energizes.
Y N
Refer to
WD 8.3 . Check the nip D release solenoid, SOL82-008. Refer to:
• GP 12 How to Check a Solenoid or Clutch.
• PJ405, Media path driver PWB.
• 01J +50V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Nip D release solenoid, PL 70.30 Item 13 .
• Media path driver PWB, PL 1.15 Item 5 .
Re-enter the dC330 codes 82-007 and 82-008. Check that nip C and nip D open fully and close
fully when the solenoids energize and de-energize. The nips operate correctly.
Y
N
Check for obstructions. Install new components as necessary:
• Horizontal paper path components, PL 82.15 .
• Left hand upper door components, PL 70.30 .
Run dC625 Registration / Preheat Calibration. If the fault persists, check the following:
• Roller drive J, PL 10.10 Item 1 .
• Roller drive L, PL 10.10 Item 2 .
• Gear drive, PL 10.10 Item 4 .
Figure 1 Component Location
Stripper blade lock
(Front and rear)
Closed
Open
Stripper blade shaft
Detent in shaft
A
B
B