Xerox ColorQube 9303 Series, Service Manual, Page: 354 / 1812

February 2013
2-330 ColorQube® 9303 Family
82-132-00, 82-155-00, 82-133-00
Status Indicator RAPs
Y N
Go to
WD 8.5 . Check horizontal transport motor (M6), MOT82-003 and the encoder wire
harness. Refer to:
• GP 10 How to Check a Motor.
• PJ905, Media path driver PWB .
• 01D +5V Distribution RAP.
• 01J +50V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Horizontal transport motor (M6), PL 82.15 Item 9 .
• Media path driver PWB, PL 1.15 Item 5 .
Check the following:
•
The bearing, shaft and rolls on the horizontal and vertical transport assembly.
• The idler rolls in the upper left side door, PL 70.30 Item 4 .
• The transport rolls for wear, PL 82.10 Item 1 , PL 82.10 Item 2 .
Install new components as necessary.
NOTE: Calibration of the registration / preheat assembly, dC625 , is only required when:
• The registration / preheat assembly is removed or replaced.
• The horizontal transport assembly is removed or replaced.
Calibration of the registration / preheat assembly is NOT required when:
• A printhead is replaced.
• The IOD assembly is removed or replaced.
82-133-00 Media Path Sensor 16 Time out from Tray 5 RAP
82-133-00 Lead edge late to the media path sensor 16 when feeding from tray 5.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP 14 . Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check the paper in tray 5.
• Check that the paper guides are set the correct paper size.
• Check tray 5 feed assembly, PL 81.45 Item 2 .
• Check for obstructions in the paper path.
• Check that the upper and middle left side doors are fully latched, PL 70.30 Item 14 , PL
70.30 Item 16 .
Procedure
Enter dC330 code 82-125 confirm sensor (16), Q82-125. Press Start. Open the left hand door
and manually actuate the sensor. The display changes.
Y
N
Go to
WD 8.1 . Check confirm sensor (16), Q82-125. Refer to:
• GP 11 How to Check a Sensor.
• PJ104, Media path driver PWB .
• 01D , +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Confirm sensor (16), PL 82.10 Item 7 .
• Media path driver PWB, PL 1.15 Item 5 .
Enter dC330 code 82-001 vertical transport motor (M2), MOT82-001. Press Start. The motor
runs.
Y
N
Go to
WD 8.1 . Check vertical transport motor (M2), MOT82-001. Refer to:
• GP 10 How to Check a Motor.
• PJ104, Media path driver PWB .
• 01D +5V Distribution RAP.
• 01J +50V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Vertical transport motor (M2), PL 82.10 Item 12 .
• Media path driver PWB, PL 1.15 Item 5 .
The vertical transport rolls rotate.
Y
N
Check the drive belt and drive gears on the vertical transport,
PL 82.10 .
A