Shihlin SA3 Series, User Manual

Page: 80 / 423

System parameter group 00
PARAMETER DESCRIPTION 78
5. PARAMETER DESCRIPTION
5.1 System parameter group 00
Group
Parameter
Number
Name Setting Range Default Page
00-00 P.90 Inverter model Read only
Read
only
82
00-01 P.188 Firmware version Read only
Read
only
82
00-02 P.996～P.999 Parameter restoration
0: Off
0 83
1: Clear alarm history (P.996=1)
2: Reset inverter (P.997=1)
3: Restore all parameters to default (P.998=1)
4: Restore some parameters to default 1 (P.999=1)
5: Restore some parameters to default 2 (P.999=2)
6: Restore some parameters to default 3 (P.999=3)
00-03 P.77
Selection of parameters
write protection
0: Parameters can be written only when the motor
stops.
0 85
1: Parameters cannot be written.
2: Parameters can also be written when the motor is
running.
3: Parameters cannot be read when in password
protection.
00-04 P.294 Password parameter 0~65535 0 85
00-05 P.295 Password setup 2~65535 0 85
00-06 P.110
Keypad monitor
selection
X0: When inverter starts, keypad enters monitor mode
automatically, screen displays output frequency.
1 89
X1: When inverter starts, screen displays target
frequency.
X2: When inverter starts, keypad enters monitor mode
automatically, screen displays current pressure and
feedback pressure of the constant pressure system in
percentage.
X5: When inverter starts, keypad enters monitor mode
automatically, screen displays current pressure and
feedback pressure of the constant pressure system.
0X：Boot screen monitors output frequency
1X：Boot screen is in target frequency setting mode
2X：Boot screen monitors output current
3X：Boot screen monitors output voltage
00-07 P.161 Multi-function display
0: Output AC voltage (V)
0 89
1: Voltage between (+/P) and (-/N) terminals. (V)
2: Inverter temperature rising accumulation rate (%)
3: Target pressure of the constant pressure system
(Unit set by 08-44(P.252))
4: Feedback pressure of the constant pressure system
(Unit set by 08-44(P.252))