Digital input/ output parameter group 03
PARAMETER DESCRIPTION 146
Parameter
Name
Default Setting Range
Content
03-00
P.83
Terminal STF input
function
0
34
RES_E (External reset, valid only when alarm.)
35
MPO (In “external mode” run manual cycle operation.)
36
TRI(Triangle wave function)
37
GP_BP (Automatic switch between inverter and commercial
power-supply.)
38
CS(Manual switch to commercial power supply)
39
STF/STR +STOP (Use with RUN signal, when ON, motor
runs reverse, when OFF, motor stops then runs forward.)
40
P_MRS (Stops inverter output immediately by pulse signal
input)
41
PWM set frequency(Note 1)
42
Reserved
43
RUN_EN (Enable digital input terminal operation)
44
PID_OFF (Enable digital input terminal turning off PID)
45
Second mode
46
Initial roll radius selection 1
47
Initial roll radius selection 2
48
Thickness selection 1
49
Thickness selection 2
50
Winding unwinding switch
51
Pre-drive command
52
Save torque value
53
Save torque value enable
54
Revs counting signal (note1)
55
Speed/Torque control
switch
56
Roll radius reset
57
High-speed pulse input function (note1)
58
Analog terminal 2-5 high priority
59
Analog terminal 3-5 high priority
60
Built-in PLC start/stop
61
SHOM (Homing enable)
62
ORGP (Set homing point)
63
Position/Speed control switch
64
External zero-servo
switch
65
External accelerate/decelerate pause
66
External forced stop
67
Roll diameter calculation stop
68
Enable single point positioning
69
Enable multipoint positioning
70
Enable entire position control by pulse input command
71
External torque command polarity reverse
99999
Off
03-01
P.84
Terminal STR input
function
1
Same as
03-00(P.83)
Same as 03-00(P.83)
