Shihlin SA3 Series, User Manual

Page: 380 / 423

Appendix 1 Parameter table
APPENDIX 378
Group
Parameter
Number
Name Setting Range Default Page
06-76 P.772
Inverter operation status code
during E2 alarm
Read only Read 200
06-77 P.773 E2 alarm date (years / months) Read only Read 200
06-78 P.774 E2 alarm date (days/hours) Read only Read 200
06-79 P.775
E2 alarm date (minutes /
seconds)
Read only Read 200
07-00 P.33
COM1 Communication protocol
selection
0: Modbus protocol
1
20
4
1: Shihlin protocol
2：PLC protocol（Effective when using Shihlin
built-in PLC）
07-01 P.36
COM1 inverter communication
station number
0～254 0 204
07-02 P.32
COM1
Serial communication
baud rate
0: Baud rate:4800bps
1 204
1: Baud rate:9600bps
2: Baud rate:19200bps
3: Baud rate:38400bps
4: Baud rate:57600bps
5: Baud rate:115200bps
07-03 P.48 COM1
data length
0: 8bit
0 204
1: 7bit
07-04 P.49 COM1 stop bit length
0: 1bit
0 204
1: 2bit
07-05 P.50 COM1 parity check selection
0: No parity check
0 204 1: Odd
2: Even
07-06 P.51 COM1 CR/LF selection
1: CR only
1 204
2: Both CR and LF
07-07 P.154
COM1
Modbus communication
format
0: 1, 7, N, 2 (Modbus, ASCII)
4 204
1: 1, 7, E, 1 (Modbus, ASCII)
2: 1, 7, O, 1 (Modbus, ASCII)
3: 1, 8, N, 2 (Modbus, RTU)
4: 1, 8, E, 1 (Modbus, RTU)
5: 1, 8, O, 1 (Modbus, RTU)
07-08 P.52
COM1 Number of
communication retries
0～10 1 204
07-09 P.53
COM1 communication interval
allowed time
0~999.8s: Checking communication timeout with
the set value
99999 204
99999: No timeout check
07-10 P.153
COM1 communication alarm
action
0: Alarm and stop freely
0 204
1: No alarm and continuing to operation
07-11 P.34
Communication EEPROM
write-in selection
0: When writing parameters in communication
mode, write in RAM and EEPROM
0 220
1: When writing parameters through
communication, only write into RAM