Shihlin SA3 Series, User Manual

Page: 389 / 423

Appendix 1 Parameter table
APPENDIX 387
Group
Parameter
Number
Name Setting Range Default Page
10-46 P.268
Regeneration avoid action voltage
level 220V : 155～400V 380V 267
440V : 310～800V 760V 267
10-47 P.269
Regeneration avoid function DC bus
voltage detection sensitivity at
deceleration
0: Prevent regeneration avoidance from failing
according to bus voltage change rate
0 267 1～5: Set the sensitivity to detect the bus
voltage change rate. Larger number, higher
sensitivity.
10-48 P.270
Regeneration avoid frequency
compensation value
0～10.00Hz: Set the limit value of regenerative
avoid frequency compensation.
6.00Hz 267
99999: Off.
10-49 P.271
Regeneration avoid
voltage gain coefficient
0～400.0%/0～40.0% 100.0% 267
10-50 P.272
Regeneration avoid frequency gain
coefficient
0～400.0%/0～40.0% 100.0% 267
10-51 P.264 Over excitation deceleration
0: Off.
0 267
1: Over excitation deceleration is valid.
10-52 P.265 Over excitation current level 0～200.0% 150.0% 267
10-53 P.266 Over excitation gain 1.00～1.40 1.10 267
10-54 P.362
Short-circuit brake time when PM
motor start
0~60.0s 0.0s 268
10-55 P.780 PLC function selection
0: Off
0
269
1: PLC RUN signal from digital input terminal
function 60 or 10-56 (P.781)。
2： PLC RUN signal from digital input terminal
function 60
10-56 P.781 PLC run
0: Off
0
269
1: PLC RUN
10-57 P.782 PLC program erase function
0: Off
0
269
1: Erase the PLC program, after erase success
parameter value is 0.
10-58
P.783 PLC choose register to monitor 0~326 0
269
10-59 P.784 PLC register monitoring value Read only
Read
only
269
11-00 P.320
Speed control proportional
coefficient 1
0～2000.0 100 272
11-01 P.321 Speed control integral time 1 0～20.00 s 0.30s 272
11-02 P.322
PI coefficient switch-over frequency
1
0～11-05(P.325)Hz 5.00Hz 272
11-03 P.323
Speed control proportional
coefficient 2
0～2000.0 100 272
11-04 P.324 Speed control integral time 2 0～20.00s 0.30s 272
11-05 P.325
PI coefficient switch-over frequency
2
11-02(P.322)～650.00Hz 10.00 272
11-06 P.326
Current control proportional
coefficient
0～20 0 272