Communication parameter group 07
PARAMETER DESCRIPTION 218
Item
Shihlin protocol
command code
Modbus
command
code
Modbus
address
Data content and function description
Monitor
inverter
data in
real-time
---
H03
H1014~
H1027
Modbus address is as follows:
H1014: digital input terminal state.
H1015: digital output terminal state.
H1016: terminal 2-5 analog input voltage
H1017: terminal 4-5 analog input current/voltage
H1018: AM1-5 terminal output voltage/current
H1019: DC bus voltage
H101A: inverter electronic thermal accumulation rate
H101B: inverter output wattage
H101C: inverter temperature rising accumulation rate
H101D: inverter NTC temperature accumulation rate
H101E: motor electronic thermal accumulation rate
H101F: PID control target pressure
H1020: PID control feedback pressure
H1021: motor rotating speed
H1022: terminal HDI input frequency
H1023: reserved
H1024: terminal AM2-5 output voltage / current
H1025: inverter output torque
H1026: terminal 3-5 input voltage
H1027: EP301 expansion card version number
H1028: power factor
H1029: output power
H102A: PM motor rotor position
H102B: motor speed(rpm)
H102C: motor speed from PG feedback
H102D: induction motor rotor position(z phase as 0)
H102E: PG card A1 B1 feedback pulse
H102F: PG card A2 B2 received pulse
Page change for
parameter
reading and
writing
Read
H7F
---
---
P mode:
H0000: P.0~P.99;
H0001: P.100~P.199;
H0002: P.200~P.299;
H0003: P.300~P.399;
H0004: P.400~P.499;
H0005: P.500~P.599;
H0006: P.600~P.699
H0007: P.700~P.799
H0008: P.800~P.899
H0009: P.900~P.999
H000A: P.1000~P.1099
H000B: P.1100~P.1199
H000C: P.1200~P.1299
Parameter group mode:
H0064: 00-00~00-99;
H0065: 01-00~01-99;
H0066: 02-00~02-99;
H0067: 03-00~03-99;
H0068: 04-00~04-99;
H0069: 05-00~05-99;
H006A: 06-00~06-99
H006B: 07-00~07-99
H006C: 08-00~08-99
H006D: 09-00~09-99
H006E: 10-00~10-99
H006F: 11-00~11-99
H0070: 12-00~12-99
H0071: 13-00~13-99
H0072: 14-00~14-99
H0073: 15-00~15-99
Write
HFF
