PerkinElmer Clarus SQ 8 MS Series, Hardware Manual

Page: 73 / 184

Maintenance
71
Typical Overall Maintenance Schedule
Performing maintenance tasks on a routine basis can reduce the overall costs of
operation. If a fault occurs, you can correct it with minimum difficulty.
Advanced maintenance that requires removing complicated mechanical assemblies
must be performed by a PerkinElmer Service Representative. For example, an
untrained individual should not attempt to remove the manifold but may be able to
perform basic maintenance such as draining and filling the forepump.
Exterior surfaces may be cleaned with a soft cloth dampened with a mild detergent and
water solution. Do not use abrasive cleaners or solvents.
All tasks should be logged into a logbook to keep a record of any problems or trends.
Daily
•
Make sure all system components are in working order.
•
Check and ensure that there are gas supplies to the GC and to the mass
spectrometer.
•
Check the air/water spectrum. Perform leak checking if necessary.
•
Enter information into a logbook.
Weekly
•
Check the tune and mass calibration. Tune if necessary.
•
Check the forepump oil level and color. Replace if necessary.
•
If equipped with a water chiller, check the water level and temperature.
•
If using CI, at the end of the day gas ballast the forepump lightly for 20
minutes.