PerkinElmer Clarus SQ 8 MS Series, Hardware Manual

Page: 71 / 184

Maintenance
69
WARNING
AVERTISSEMENT
Do not attempt to make adjustments, replacements or repairs to
this instrument except as described in the accompanying user
documentation.
N'essayez pas de faire des ajustements, des remplacements ou
des réparations à cet instrument, sauf comme décrit dans la
documentation de l'utilisateur qui l'accompagne.
NOTE: This equipment requires no specified inspection or preventive maintenance to ensure
the continuous functioning of its safety features.
Cleanliness and care are of critical importance whenever internal assemblies are
removed from the instrument.
•
Always prepare a clear, clean work area.
•
Make sure that any required tools or spare parts are close at hand.
•
Obtain small containers to store screws, washers, spacers etc.
•
Never touch any internal source parts with your bare fingers.
•
Use tweezers and pliers whenever possible.
•
If nylon or cotton gloves are used, prevent leaving fibers in sensitive areas.
NEVER use rubber gloves.
•
Before reassembling and replacing dismantled components, inspect O-rings and
other vacuum seals for damage. If you in doubt, replace the O-rings and vacuum
seals with new ones.
If a fault occurs soon after repairing or disturbing a particular part of the system,
ensure that this part has been correctly refitted and/or adjusted and that any adjacent
components have not been inadvertently disturbed.