108
Editing Parameters for Logic Terminals (DST1-XD0808SL-1)
Section 4-2
Selecting the Mode
1,2,3...
1.
Click the selection button shown in the following figure.
Corresponding output terminals are used as a dual output (e.g., 2 Safety
Relays).
The following options will be displayed.
2.
Select the output condition.
The options are as follows:
(1) Remote I/O Output
Outputs the signal that the logic terminal received from the Safety Mas-
ter.
When this option is selected, the result of the internal logic is ignored.
(1)
(2)
Summary of Contents for DeviceNet Safety
