321
Appendix A
2.
Set the device information and I/O information.
The device information can be obtained from a device in the network when it is online.
3.
Click the
Obtain from Device
Button. The following window will be displayed.
4.
Set the node address for a target device and click the
OK
Button.
Refer to the relevant device manual and set an I/O connection and an I/O size that the device supports.
5.
Click the
OK
Button.
The file will be added to the Hardware List Window as a new device in the same way as in the EDS file in-
stallation.
Note
The device parameter settings cannot be created using the EDS file creation function of the Network
Configurator. To set device parameters, obtain the EDS file from the device manufacturer.
A-4-3
Deleting EDS Files
EDS File
-
Delete
Use the following procedure to delete an EDS file.
1.
Select the hardware (i.e., device) in the Hardware List Window.
2.
Select
EDS File
-
Delete
.
A confirmation window will be displayed. An example is shown below.
Summary of Contents for DeviceNet Safety
