Omron DeviceNet Safety, System Configuration Manual

Page: 341 / 376

307
Appendix A
A-3 Editing Parameters for CS/CJ-series EtherNet/IP Units
This appendix describes how to edit the parameters in a CS/CJ-series EtherNet/IP Unit using the Network
Configurator.
A-3-1 Example of Setting Parameters Using a CS/CJ-series EtherNet/IP
Unit
Use the following procedure to set parameters for standard communications with an NE1A-series Controller
that supports EtherNet/IP.
1. Make the Standard Target settings for NE1A-series Controllers that support EtherNet/IP. For details on mak-
ing the settings, refer to
5-4 Setting the Controller as an EtherNet/IP Standard Target .
2. Create and group the tags using a CS/CJ-series EtherNet/IP Unit.
Note With a CS/CJ-series EtherNet/IP Unit, create tag sets that are the same size as the EtherNet/IP target I/
O set for the NE1A-series Controller.
3. Set the connections.
Creating Tags and Tag Sets
Creating a Tag Set
Use the following procedure to create tags.
1. Double-click the icon of the device (for which a tag set is being created) to display the Edit Device Parame-
ters Dialog Box. Right-click the icon to display the pop-up menu, and select
Parameter - Edit .
2. Click the Tag Sets Tab at the top of the Edit Device Parameters Dialog Box. There are two kinds of tag sets:
input (consume) and output (produce).