xxiv
Unit Versions of NE1A-series Controllers
Checking the Unit Version
A “unit version” has been introduced to manage NE1A-series Safety Network
Controllers according to differences in functionality accompanying Unit
upgrades, even though the model numbers are the same.
The unit version can be checked on the product itself or using the Network
Configurator.
Note
The Network Configurator maintains a revision number to manage device
functions for DeviceNet and EtherNet/IP. Refer to “Checking the Unit Version
with the Network Configurator” on page xxiv for the relationship between
NE1A-series Controller unit versions and the revisions.
Checking the Unit
Version on the Product
Nameplate
The unit version (Ver.
@
.
@
) is listed near the lot number on the nameplate of
the products for which unit versions are being managed, as shown below.
• The unit versions of the NE1A-SCPU01, NE1A-SCPU02, NE1A-SCPU01-
EIP, and NE1A-SCPU02-EIP Controllers begin from Ver. 1.0.
• Controllers that do not have a unit version listed on the label are called
Pre-Ver. 1.0 Controllers.
Product Nameplate
Checking the Unit
Version with the
Network Configurator
The following procedure can be used to check the unit version from the Net-
work Configurator Ver. 1.6 or higher.
1.
Select
Network - Upload
to upload the configuration information.
The unit version is listed here.
(Example: Ver. 1.0)
Summary of Contents for DeviceNet Safety
