255
Replacing a Device
Section 9-7
The following message will be displayed when upload has been complet-
ed.
4.
Click the OK Button.
Note
When replacing a device with a new device, the new device must be in default
status. If a device is replaced with a configured device, the correct network
number may not be set, which would prevent establishing connections for
Safety I/O. Refer to
9-5-2 Specifying the Network Number
for information on
network numbers.
5.
After replacing the device, click the
Yes
Button.
• If the Maintenance Tool is connected directly to a device via a USB ca-
ble, remove the USB cable and replace the device. Connect the USB
cable to the new device and click the
Yes
Button.
6.
Confirm the device parameters to be downloaded, and then click the
Close
Button.
7.
Click the
Yes
Button.
• The following dialog box will be displayed if the configuration is locked.
Summary of Contents for DeviceNet Safety
