142
Local I/O Settings
Section 5-5
Note
(1) Can be selected only when the terminal number is an even number.
(2) Can be selected only when the terminal number is an even number and
there are at least four remaining terminals.
5.
Click the
Next
Button. The following dialog box will be displayed.
6.
Check the settings and then click the
Finish
Button.
Setting I/O Terminal Comments
In the window for setting input and output terminals, click the
Edit I/O Com-
ments
Button. The following dialog box will be displayed.
The comments for the I/O terminals can be edited in this dialog box.
SLC 1 output
Specify to use one input from a light curtain.
Other PNP 2 outputs (See note 1.) Specify to use two inputs from other semiconductors.
Other PNP output
Specify to use one input from other semiconductors.
Reset SW
Specify to use inputs from a reset switch.
Welding Check (EDM input)
Specify to use as EDM feedback signal.
Standard SW
Specify to use inputs from a switch for non-safety applications.
Not Use
Specify to not use the input.
Type
Description
Summary of Contents for DeviceNet Safety
